Day 1
Introduction to ProMECHANICA
Simplifying Models with Idealizations
Optimizing Models for Analysis

Day 2
Assigning Material Properties
Applying Constraints
Simulating Applied Loads

Day 3
Running and Evaluating Analyses
Analysis and Results Examples

Day 4
Running Sensitivity and Optimization Studies
Running Analyses
Advanced Exercises

Day 5
Fatigue Advisor
Student Projects

Day 1
Introduction
Creating Design Frameworks
Communicating Design Information

Day 2
Analyzing and Modifying Assembly Structures
Managing Complex Parts
Creating Simplified Representations

Day 3
Replacing and Substituting Components
Modifying Simplified Representations
Managing Complex Drawings
Project

Day 1
Introduction to Surface Modeling
Getting Started with Surface Modeling
Using References to Create Surface Models
Building Foundation for Surface Models　I
Project Laboratory Day 1

Day 2
Building Foundation for Surface Models II　
Building Models with Sections and Trajectories I
Building Models with Sections and Trajectories II
Project Laboratory Day ２

Day 3
Modeling with Boundaries
Interactive Surface Modeling
Manipulating Surfaces and Quilts
Project Laboratory Day 3

Day 4
Redefining Solid Models Using Quilts
Evaluating Surface Models
Creating Smooth Surface Models
Project Laboratory Day 4

Day 5
Adding Details to the Base Surface Models
Dealing with Complex Modeling Situations
Converting Quilts into Solids
Project Laboratory Day 5

Day 1
Introduction to Sheetmetal Design
Primary Walls
Secondary Walls
Unbend, Bend back and Cuts
Notches and Punches V

Day 2
Duplicating Features
Sheetmetal Forms
Bend Features
Unbending Sheetmetal Geometry
Sheetmetal Design Environment

Day 3
Converting Solid Parts
Project Laboratory
Documenting Sheetmetal Design
Sheetmetal Design Information

Day 1
Introduction to ProENGINEER Wildfire
Editor Design Model
Create a reference to the geometric
Create direct characteristics

Day 2
To capture the design intent using "Sketch device"
Create characteristics based on the Sketch
Create characteristics based on the Sketch
Project I

Day 3
Duplicate the design of model features
Strengthen the design model
Assembly components
Project II

Day 4
Creat institute connection
Create graphics
Renewable failure to resolve
Project III

Day 5
Management components
Analysis and optimization design model
Project IV